Description

Reference standards: UNI EN ISO 5269-2: 2005 – DIN 54358

One-column sheet former

The Sheet Former is built upon a warp resistant stainless steel frame. This robust base holds the pump, hot water bath, suction chamber, etc. On the left-hand side of the working table you can find the sheet forming column. The dryer is located on the right-hand side. There are only a few important control switches on the working table in order to ensure work space for the transferring process between sheet former and dryer. The sheet forming process is controlled by a Simatic control system. The temperature and the vacuum of the drying process are adjusted on the touchscreen.

Specifications

• Built into a sturdy stainless steel frame
• Former column made from stainless steel
• Integrated water-resistant touchscreen control panel
• Easy and intuitive operation via touchscreen
• Fully automatic sheet forming
• Additional 6-position switch to change to manual sheet forming at any time

Connections

Electricity: 230 V, 50 Hz AC without dryer (other voltages on request possible)

400 V, 50 Hz AC with dryer (other voltages on request possible)

Air: 400 – 600 kPa

Water: tap water connection required

Drainage:        Ø50 mm drainage pipe